Liquefied air separation FAQ

The site should be carefully checked for the chiller type and evaporator design pressure. It is not possible to use the water inlet as a water outlet and vice versa: the water flow switch is determined to be installed. The first start-up must be carried out under the guidance of the chiller plant manufacturer's personnel. Do not power on the chiller without permission. The installation requirements of the chiller plant are reflected in the operating instructions and the chiller plant manufactur...

LNG Cold Energy Utilisation Air Separation Plant is a liquid air separation plant for the utilization of LNG cold energy with a high utilization rate of cold energy, energy saving and environmental protection, high efficiency and safety factor. Liquid air separation plant for LNG cold energy, including air compression pre-cooling system, purification system, air separation system, nitrogen circulation system. The nitrogen circulation system consists of a high pressure heat exchanger to recover ...

The liquid air separation plant includes the lower tower, upper tower, condensing evaporator, argon system, main heat exchanger, subcooler, liquefier and is placed in a separate cold box. After distillation in the lower tower, high purity nitrogen is obtained at the top of the lower tower, which is reheated by the main heat exchanger and then exits the cold box and goes to the nitrogen circulation system to recover the cold from the liquid air separation plant to make liquid nitrogen. The lower ...

(1) Can be based on the cold box outside the piping diagram provided by the equipment manufacturer and the relevant national standards and norms for industrial piping installation. For heavier weight valves, small lifting tools can be used to temporarily support them. When the piping is good, use fixed brackets to support. (2) Liquid discharge mains should be installed with compensation parts. (3) The aluminium pipe leading out of the cold box with its welded pressure plate and its seal ring s...