FAQ

Why do air separation equipment remove impurities in the air?

What impact does air volume of air separation equipment have on rectification tower?

  Since the successful development of the first set of high-purity nitrogen air separation unit in China in 1978, the R & D breakthrough of domestic nitrogen production equipment has closely followed the pace of foreign countries, and has achieved leapfrog development in recent decades. At the same time, China's nitrogen production market also shows an upward trend year by year, and the demand for nitrogen p...

In the liquid air separation plant, the cooled refrigerant goes to the air machine through the refrigerant delivery pipeline, and the intercooler cools the compressed air to around 10°C, improving the efficiency of the air compressor and reducing the energy consumption of the air compressor. The air separation unit uses circulating nitrogen to recycle and utilise the CNG cold through a heat exchanger, which in turn liquefies the air to transfer the cold to the liquid air separation plant, an...

The plant operation cycle between two large heating is related to many factors. From an operational point of view, this mainly depends on when the air passage of the main heat exchanger is blocked. The main reason for the blockage is that the moisture and carbon dioxide content in the air entering the unit exceeds the standard, which accumulates and freezes in the main heat exchanger until it is blocked. The abnormal operation of molecular sieve purification system will shorten the operation cycle of the unit. It is mainly caused by the following reasons: 1. The molecular sieve adsorption bed is short circuited. In the process of operation, due to the unstable gas velocity control or switching, the pressure difference between the two tanks is too large, which will affect the bed layer, make the molecular sieve bed uneven and make the bed layer short circuit. In serious cases, the dust screen of the adsorber will break and the molecular sieve powder will enter the heat exchanger c

What is the oxygen internal compression process

Pipe of small air separation unit before installation, check the orientation of the container orifice, the orientation of the valve inlet and outlet is correct. The pipe fittings should be thoroughly cleaned ten net and strictly degreased, while opening the welding bevels etc. The welded pipe must be brushed with clean stainless steel wire for a very short time before welding. In order to reduce the cold box pipe welding mouth, can be prefabricated in a clean plant, and later for the final dist...

Liquid layer on sieve plate