How to reduce cold loss caused by temperature difference at the hot end of air separation equipment...
1 pay attention to the direction of the arrow on the valve and the process requirements of the media flow direction, in order to avoid installation er...
When the exhaust temperature of the piston compressor is higher than the design value, the most direct impact is that the lubricating oil is carbonize...
Generally, the actual cooling capacity of expander is always less than the theoretical cooling capacity. Under the same inlet and outlet pressure and ...
Decarbonisation of large ammonia plants using the dual high pressure adsorption process can be seen as using PSA decarbonisation as a pre-treatment un...
LNG Cold Energy Utilisation Air Separation Plant is a liquid air separation plant for the utilization of LNG cold energy with a high utilization rate ...
Causes of molecular sieve into the water accident: when the air-cooled tower level is higher than 3500mm water exceeds the height of the air inlet tub...
How to judge whether the molecular sieve purifier works normally according to its adsorption temperature...
Gas-liquid separation is one of the simplest and most common methods of gas pretreatment. Many process gases in industrial plants, such as steam re...
How to prevent water ingress into molecular sieves in air separation equipment?...
What are the impacts of scaling in the cooling system of air separation equipment and how can it be prevented?...
Before starting, the following preparations should be done first: 1) Check whether the unit has the starting conditions (including the reason of last ...
