The temperature condition adjustment of the cooler (or switching heat exchanger) is based on the central temperature. The "middle" mentioned here does...
I. Preface With the rapid development of industry, nitrogen has been widely used in chemical engineering, electronics, metallurgy, food, machinery an...
The start-up phase of the whole low-pressure oxygen generator is that liquid empty appears first in the lower tower, and then liquid oxygen appears in...
After the argon fraction is extracted from the top Tower, it enters into the crude argon tower and conducts the separation of oxygen and argon by the ...
Saturation temperature and saturation pressure are terms in gas-liquid equilibrium. If it is not filled with liquid in a sealed container, part of liq...
In the air separation plant, the adsorption capacity of the adsorbents is expressed by static adsorption capacity and dynamic adsorption capacity. The...
Before starting, the following preparations should be done first: 1) Check whether the unit has the starting conditions (including the reason of last ...
Core tips: the safety that should be paid attention to when touching nitrogen: nitrogen is colorless, odorless and odorless lazy gas. It itself does n...
Almost all motors commonly used in the air separation plant are three-phase AC motors. Three-phase AC motor can be divided into asynchronous motor and...
When the general motor in the air separation plant is started, the current that the stator of the motor takes from the power grid is about 5 ~ of the ...
When the power supply of the air separation unit of the molecular sieve adsorption purification process is resumed after the power failure, the operat...
A user of DEAR air separation reflected that when the air separation plant was put into operation, a large liquid nitrogen storage tank was equipped f...