当前位置: Home / Faq / Small air separation FAQ /

Pressure test and gas tightness test for small air separation unit

Pressure test and gas tightness test for small air separation unit
Jan 20, 2022
Author: DEAR AST

1.1 The water used for the pressure test shall be clean domestic water ,for containers with complex structures or distillation towers, plate fin heat exchangers, condensing evaporators, adsorbers, filters, etc., which should not be used as a medium, the air pressure test is available.

1.2 Gas tightness test for dry oil-free clean air or nitrogen.

Test pressure categories: strength air pressure test, test water pressure test, gas tightness test

Pressure vessel

3.1 Level pressure gauge test nitrogen seal pressure.

3.2 multi-channel vessel test sealing nitrogen in doubt or no sealing nitrogen must be pressure test to verify whether there is internal leakage.

3.3 Oxygen is strictly forbidden to be used as test pressure gas

Valve

4.1 Where the need for on-site degreasing, disassembly and inspection of the valve before installation shall be a separate gas tightness test.

4.2 The safety is only tested by jumping. After reaching the requirements can be sealed, where the safety valve before the shut-off valve ,the valve must be kept fully open and sealed.

4.3 Pneumatic film control valves need to make the following checks before installation: leakage check, positioner action test,packing letter, flange sealing surface for leakage inspection.

Dear Air Separation manufactures small air separation unit that meets customer requirements and is pressure tested and gas tight tested.

山东传洋集团20000

DEAR Air Separation Solve YourPressure test and gas tightness test for small air separation unitYou can also learn about otherSmall air separation FAQ about DEAR Air Separation, and solve the problem for you.
Didn’t find the problem encountered?
Please contact live chat or email for quick help.
Related FAQ
More Related FAQ
The liquefaction of gases can be divided into forward and reverse cycles. The forward cycle process is the absorption of heat from the higher temperature external heat source and the release of heat to the lower temperature external heat source. The reverse cycle is when the mass draws heat from a lower temperature external heat source and releases it to a higher temperature external heat source. The forward cycle converts heat energy into mechanical energy and the reverse cycle converts mechani...
2025.09.26
Distillation is using the different boiling points of the two substances to condense the mixed steam and vaporize the mixed liquid repeatedly to achieve gas separation. For a mixed liquid composed of two substances with different boiling points, when the heat absorption part evaporates, the volatile components will evaporate more, while the mixed steam will give off heat and partially condense, the non volatile components will condense more. If the saturated steam with higher temperature is mixed with the saturated liquid with lower temperature, the steam will release heat and partially condense, and the liquid will absorb heat part of it evaporates. If after a round of partial evaporation and partial condensation, the steam and liquid with higher concentration will contact with the steam and liquid with different temperature respectively, and then partial condensation and partial evaporation will occur again. This process will be repeated for many times, and finally gas separation
2025.09.25
Need more information?
Contact us for more details about our air separation equipment, solutions and services.
Products
  • Large air separation
  • Small air separation
  • High purity nitrogen air separation
  • Liquefaction air separation
  • Complete air separation
  • Biogas purification
  • Air separation parts
Need more information?
Tel:+86-19837850537
© Kaifeng DEAR Air Separation Industry Co., Ltd.. All rights reserved.
Online
Inquiry
Email
Top