当前位置: Home / Faq / Small air separation FAQ /

Why does the time it takes for the oxygen concentrator of the air separation equipment to accumulate liquid during startup differ

Why does the time it takes for the oxygen concentrator of the air separation equipment to accumulate liquid during startup differ
Dec 05, 2023
Author: DEAR AST

The process of accumulating the necessary low-temperature liquid for distillation in a distillation tower is actually a process of storing cold energy. The cooling balance relationship during this process is: total cooling capacity=total cooling loss+cooling capacity required for liquid accumulation

For the same oxygen concentrator, the amount of accumulated liquid required is the same, so the required cooling capacity is also the same. However, the total cooling capacity and total cooling loss of an oxygen concentrator are related to specific conditions, and sometimes there is a significant difference. It is related to the installation, maintenance quality, and operation during the start-up phase of the oxygen concentrator.

The time it takes to accumulate liquid is also related to the heating of the equipment (including the heating of the insulation layer) before startup, as well as whether the equipment and insulation layer inside the cooling tower cool evenly and thoroughly after startup. If the temperature is too high at the end of heating and the cooling stage is not fully cooled, the liquid that appeared earlier will evaporate a large amount after being injected into the upper tower. At the same time, the heat stored in the insulation layer (the amount of cooling required to cool the insulation layer is often greater than the amount of cooling required for the entire liquid accumulation stage) continues to flow into the tower, causing the liquid level to remain stagnant or rise slowly, prolonging the time required for this stage.

DEAR Air Separation customers with complete and efficient engineering and technical solutions to meet their needs.

DEAR Air Separation Solve YourWhy does the time it takes for the oxygen concentrator of the air separation equipment to accumulate liquid during startup differYou can also learn about otherSmall air separation FAQ about DEAR Air Separation, and solve the problem for you.
Didn’t find the problem encountered?
Please contact live chat or email for quick help.
Related FAQ
More Related FAQ
What's the reason for using two-stage distillation column in air separation column?Usually, the air in the lower column is pre separated by the air separation column, which is rectified into liquid air which is rich in oxygen and pure nitrogen, and then further rectified in the upper column to obtain oxygen and nitrogen products. The connection between the upper and lower columns is the condensing evaporator. It uses the pressured nitrogen of the lower column to heat the liquid oxygen in the upper column, so as to evaporate the liquid oxygen while condensing the liquid nitrogen. The advantage of using two-stage distillation column is that the product has high extraction rate, and high purity oxygen and nitrogen can be obtained at the same time. Oxygen and nitrogen products can also be produced in a single-stage distillation column, but only one product can be produced separately. It is similar to the lower column of two-stage distillation column, in which pure nitrogen product can be
2026.11.17
Answer: to judge whether the air separation unit is advanced or not, it mainly depends on three hard indicators, combined with the comprehensive evaluation of the intelligent level. 1. Core evaluation index -Unit power consumption: commonly measured in kwh/nm ³ o ɑ, it is the operating cost index that customers are most concerned about; The larger the scale and the higher the purity, the lower the unit energy consumption. -Oxygen extraction rate: it reflects the utilization efficiency of raw air. The higher the extraction rate, the more electricity is saved. The cryogenic method is usually better than the simple process. -Operation stability and load regulation range: whether the load can be changed smoothly between 30% and 110% will directly affect the ability of adaptive gas fluctuation. 2. Embodiment of the advanced nature of Deere air separation -The eighth generation of intelligent air separation technology: make system optimization in process organization and equipment matching,
2026.11.16
Need more information?
Contact us for more details about our air separation equipment, solutions and services.
Products
  • Large air separation
  • Small air separation
  • High purity nitrogen air separation
  • Liquefaction air separation
  • Complete air separation
  • Biogas purification
  • Air separation parts
Need more information?
Tel:+86-19837850537
© Kaifeng DEAR Air Separation Industry Co., Ltd.. All rights reserved.
Online
Inquiry
Email
Top