当前位置: Home / Faq / Air separation parts FAQ /

What should be done when the power supply of the air separation plant of the molecular sieve adsorption purification process is restored after the power failure?

What should be done when the power supply of the air separation plant of the molecular sieve adsorption purification process is restored after the power failure?
Oct 10, 2024
Author: DEAR AST
Question Reply

Molecular sieve adsorption purification processAir separation equipmentWhen the power supply is restored after the power failure, the operation should follow the following steps:
1) judge the possible influence on mechanical equipment such as air compressor when the power is suddenly cut off. If there is no influence, according to the operation specification of the air compressorAir compressorStart-up preparation;
2) check and confirm the switch state of the chain shutdown equipment valve;
3) check and confirm the alarm chain project of the air separation plant. Re-check and confirm the chain control of failure during power failure;
4) start the air compressor and air precooling system according to regulations;
5) start the molecular sieve adsorber according to the regulations. Continue to complete the process before shutdown. If the downtime is long (more than 24 h), the molecular sieve adsorber should recycle for one cycle;
6) according to the length of downtime, the cold end temperature of the main heat exchanger and the main cold liquid level, etc., according to the regulations to determineAir separation equipmentStart the startup procedure.

DEAR Air Separation Solve YourWhat should be done when the power supply of the air separation plant of the molecular sieve adsorption purification process is restored after the power failure?You can also learn about otherAir separation parts FAQ about DEAR Air Separation, and solve the problem for you.
Didn’t find the problem encountered?
Please contact live chat or email for quick help.
Related FAQ
More Related FAQ
The liquefaction of gases can be divided into forward and reverse cycles. The forward cycle process is the absorption of heat from the higher temperature external heat source and the release of heat to the lower temperature external heat source. The reverse cycle is when the mass draws heat from a lower temperature external heat source and releases it to a higher temperature external heat source. The forward cycle converts heat energy into mechanical energy and the reverse cycle converts mechani...
2025.09.26
Distillation is using the different boiling points of the two substances to condense the mixed steam and vaporize the mixed liquid repeatedly to achieve gas separation. For a mixed liquid composed of two substances with different boiling points, when the heat absorption part evaporates, the volatile components will evaporate more, while the mixed steam will give off heat and partially condense, the non volatile components will condense more. If the saturated steam with higher temperature is mixed with the saturated liquid with lower temperature, the steam will release heat and partially condense, and the liquid will absorb heat part of it evaporates. If after a round of partial evaporation and partial condensation, the steam and liquid with higher concentration will contact with the steam and liquid with different temperature respectively, and then partial condensation and partial evaporation will occur again. This process will be repeated for many times, and finally gas separation
2025.09.25
Need more information?
Contact us for more details about our air separation equipment, solutions and services.
Products
  • Large air separation
  • Small air separation
  • High purity nitrogen air separation
  • Liquefaction air separation
  • Complete air separation
  • Biogas purification
  • Air separation parts
Need more information?
Tel:+86-19837850537
© Kaifeng DEAR Air Separation Industry Co., Ltd.. All rights reserved.
Online
Inquiry
Email
Top