当前位置: Home / Faq / High purity nitrogen air separation FAQ /

Boiling point of oxygen nitrogen mixture in air separation equipment

Boiling point of oxygen nitrogen mixture in air separation equipment
May 12, 2023
Author: DEAR AST

Oxygen and nitrogen have a certain state under certain conditions. When the temperature reaches the boiling point under certain pressure, they will change from a liquid state to a gaseous state. When the pressure is constant, both oxygen and nitrogen have their fixed boiling points. But the boiling point of a mixture of oxygen and nitrogen is neither equal to the boiling point of oxygen at the same pressure nor the boiling point of nitrogen at the same pressure, but between the two. When the temperature reaches the boiling point of nitrogen, the mixture will not boil, and similarly, when the temperature drops to the condensation temperature of oxygen, the mixture will not condense.

DEAR Air Separation enhances the performance of distillation columns and extensively uses structured fillers in their distillation columns. This type of filler can replace saddle mesh filler θ Mesh ring packing can also replace sieve tray towers. It has high mass transfer efficiency and small resistance drop. It is a preferred internal component for distillation columns in ultra-low pressure process air separation equipment. The Tianjin University ZUPAC PLUS structured packing selected for Deer Air Separation can significantly reduce pressure, improve separation efficiency, and reduce liquid holding capacity. The start-up time of the device has also been significantly reduced.

DEAR Air Separation Solve YourBoiling point of oxygen nitrogen mixture in air separation equipmentYou can also learn about otherHigh purity nitrogen air separation FAQ about DEAR Air Separation, and solve the problem for you.
Didn’t find the problem encountered?
Please contact live chat or email for quick help.
Related FAQ
More Related FAQ
Why is the cryogenic air separation air compression system the most power consuming link?
2026.03.23
Screw compressor is a positive displacement compressor from the mechanical type, which is composed of the driving rotor and driven rotor, the main body and a pair of synchronous gears. Therefore, the common faults of screw compressor are as follows: 1. The bearing is burnt out. Because of the foreign matter in the oil system, the oil pressure and the quality of the oil are reduced, resulting in the bearing burning out. The main treatment methods are: check the oil supply system; clean the oil filter and the cooling pipe of the oil cooler; check and adjust the oil pressure regulating valve; test the oil quality, and replace the oil when it is not good; check and deal with the oil leakage points. 2. The rotor is burnt out. When foreign matters enter into the compressed medium system, the temperature of the rotor rises, the temperature of the cooling oil of the rotor increases due to the high temperature of the inhaled medium, and the compression ratio increases, which may cause the
2026.03.20
Need more information?
Contact us for more details about our air separation equipment, solutions and services.
Products
  • Large air separation
  • Small air separation
  • High purity nitrogen air separation
  • Liquefaction air separation
  • Complete air separation
  • Biogas purification
  • Air separation parts
Need more information?
Tel:+86-19837850537
© Kaifeng DEAR Air Separation Industry Co., Ltd.. All rights reserved.
Online
Inquiry
Email
Top