当前位置: Home / Faq / Small air separation FAQ /

Inspection of the pipeline in small air separation unit

Inspection of the pipeline in small air separation unit
Feb 18, 2022
Author: DEAR AST

Before installing pipe , check the orientation of the container orifice, the orientation of the valve inlet and outlet is correct. The pipe fittings should be thoroughly cleaned ten net and strictly degreased, while opening the welding bevels etc. The welded pipe must be brushed with clean stainless steel wire for a very short time before welding.

In order to reduce the cold box pipe welding mouth, can be prefabricated in a clean plant, and later for the final distribution. Piping principles, first big pipe, then small pipe, first lower, then upper, first in charge, then auxiliary pipe.

The pipes must be naturally aligned before welding. Forced alignment with the help of manpower is never allowed, in order to avoid increased buttressing stress. If the pipework cannot be carried out continuously during installation, the openings must be covered or wrapped with plastic sheeting. The pipe rack in the cold box should be kept stable enough for the pipe rack to be installed and should not be shaken at will, taking into account the thermal expansion and contraction of the pipe and self-compensation, and in accordance with the requirements of the pipe rack diagram.

Dear Air Separation piping is checked in strict accordance with the standards before installation to ensure the safety of the piping installation in small air separation unit.

2

DEAR Air Separation Solve YourInspection of the pipeline in small air separation unitYou can also learn about otherSmall air separation FAQ about DEAR Air Separation, and solve the problem for you.
Didn’t find the problem encountered?
Please contact live chat or email for quick help.
Related FAQ
More Related FAQ
In case of sudden power failure during the operation of small air separation unit, the following steps should be followed:   First, open the vent valve (anti surge valve) of air compressor to prevent the air compressor from surging and causing the air compressor to reverse due to air backflow;   Then check whether the molecular sieve adsorber switch should be interlocked to close, if not, it should be man...
2024.11.21
How is the ratio of individual gases adjusted in an air separation plant?
2024.11.20
Need more information?
Contact us for more details about our air separation equipment, solutions and services.
Products
  • Large air separation
  • Small air separation
  • High purity nitrogen air separation
  • Liquefaction air separation
  • Complete air separation
  • Biogas purification
  • Air separation parts
Need more information?
Tel:+86-19837850537
© Kaifeng DEAR Air Separation Industry Co., Ltd.. All rights reserved.
Online
Inquiry
Email
Top