Home / All Air Separation tags /

Small biogas purification unit

Small biogas purification unit
With the increasing attention to environmental problems, people began to use various ways to reduce the damage of industrial and agricultural production to the environment. Therefore, more and more small biogas purification unit used by users to treat livestock manure and various production and domestic sewage has been put into use. Small biogas purification unit has the characteristics of simple operation and low cost. Colleagues can also recycle energy, which is widely welcomed at home and abroad.
News of Small biogas purification unit
More
Dec 11, 2020
On December 7, 2020, Kaifeng DEAR air separation Industrial Co., Ltd. (hereinafter referred to as: DEAR air separation) and Shaangu Group once again j
Faq of Small biogas purification unit
More
1.The cold box foundation is divided into frame type and non frame type. The levelness of top surface of frame type frame shall not exceed 1 / 1000. All sections of the frame shall be placed vertically. All bottom plates of non frame type cold box shall be kept at the same level, and the levelness shall not exceed 1 / 1000.   2.When installing the cold box plate, the adjacent two sides can beassembled into a whole piece or angle type on the ground. The length error of each diagonal line a...
Dec 23, 2020
Air cooling column is a mixed heat exchange device. The function is to make the cooling water fully contact with the air and being mixed fully to increase the heat transfer area and enhance the heat transfer, usually using "packed column" or "sieve plate". The packed column is a round steel container with packing (ceramic ring, plastic ring, etc.). Cooling water is ejected from the top of the column and mixed with air flowing upward from the bottom for heat and mass exchange. Air transfers heat to the cooling water, lowering its temperature and raising its temperature. In order to prevent the generation of water droplets in the air, the raschig ring (or stainless steel wire mesh) packing separator (also known as trapping layer) and mechanical water separator (inertial separation) are usually installed on the upper part of the column. The cooling water ejected from the spray device flows downward to the packing layer through the distributor, and an overflow ring is provided to redist
Dec 04, 2020
© Kaifeng DEAR Air Separation Industry Co., Ltd.. All rights reserved.
Online
Inquiry
Email
Top