Air separation plant accessory factory

The design of the internal structure of the adsorber: the design of the internal structure of the adsorber includes the determination of the bed layer and various auxiliary structures, such as the design of the upper and lower filter, the guide valve, the pressing mechanism, the gas distribution device and so on. The adsorber can usually be divided into single bed and double bed, and the structure is shown in figure 3. Both the upper and lower vent of the two structures are equipped with filter and gas distributor. The single-layer bed structure is equipped with a screen hole plate and a cylinder compressing device on the molecular sieve adsorber. When the adsorber is working, the cylinder piston generates a lower thrust by differential pressure and compresses the molecular sieve through the screen hole plate, it avoids the phenomena that the molecular sieve is boiling and flowing and the filter screen is damaged due to the excessive airflow, thus prolonging the life of the molecula...

1. Adhere to the electrical professionals to work with certificates, non electrical professionals are not allowed to replace or repair any electrical components. 2. Establish the temporary electricity inspection system, inspect and irregularly inspect various lines and facilities on site according to the temporary power management regulations, and archive the inspection and spot check records. 3. The inspectors and operators must wear insulating rubber shoes and gloves according to the regulations; they must use special insulating tools for electricians. 4. The temporary distribution lines must be erected according to the specifications. The overhead lines must be insulated wires, plastic flexible wires, bundles of overhead laying and surface laying along the ground. 5. The erection and use of temporary electricity on the construction site must comply with the provisions of technical code for safety of temporary electricity on construction site (JGJ46-88). 6. Constructio