Energy-saving air separation plant

There must be enough smooth straight pipe sections before and after the flow orifice plate. The distance is 10 times of pipe diameter in front of the orifice plate and 5 times of the pipe diameter behind the orifice plate, and no factors affecting the measurement accuracy (such as pipe joint, etc.) are allowed. The inner surface of the pipe weld should also be ground smooth, and the gasket should not extend into the inner diameter of the pipe. And carefully check the installation direction of the orifice plate, do not install it in reverse. (judgment method: the small exit is the entrance, and the large exit is the outlet)

1. Before hoisting, check and confirm whether the crane body, crane legs, lifting rigging and wire rope meet the safety requirements and hoisting conditions. 2. The hanging points of hoisting facilities shall be confirmed to prevent deviation and inclination; steel wire rope or sling shall be used for protection of edges and corners; sling and U-ring shall be used for lifting objects. 3. The commander shall use inter-phone for command, and special personnel shall be assigned for command, and the personnel shall stand at the position where the lifting object can be fully observed; warning isolation shall be set up in the hoisting area, and no one shall stand under the lifting object. 4. For large-scale hoisting, the hoisting safety scheme shall be formulated in combination with the company's special operation system.