Air separation unit valve

The plant operation cycle between two large heating is related to many factors. From an operational point of view, this mainly depends on when the air passage of the main heat exchanger is blocked. The main reason for the blockage is that the moisture and carbon dioxide content in the air entering the unit exceeds the standard, which accumulates and freezes in the main heat exchanger until it is blocked. The abnormal operation of molecular sieve purification system will shorten the operation cycle of the unit. It is mainly caused by the following reasons: 1. The molecular sieve adsorption bed is short circuited. In the process of operation, due to the unstable gas velocity control or switching, the pressure difference between the two tanks is too large, which will affect the bed layer, make the molecular sieve bed uneven and make the bed layer short circuit. In serious cases, the dust screen of the adsorber will break and the molecular sieve powder will enter the heat exchanger c

Air cooling column is a mixed heat exchange device. The function is to make the cooling water fully contact with the air and being mixed fully to increase the heat transfer area and enhance the heat transfer, usually using "packed column" or "sieve plate". The packed column is a round steel container with packing (ceramic ring, plastic ring, etc.). Cooling water is ejected from the top of the column and mixed with air flowing upward from the bottom for heat and mass exchange. Air transfers heat to the cooling water, lowering its temperature and raising its temperature. In order to prevent the generation of water droplets in the air, the raschig ring (or stainless steel wire mesh) packing separator (also known as trapping layer) and mechanical water separator (inertial separation) are usually installed on the upper part of the column. The cooling water ejected from the spray device flows downward to the packing layer through the distributor, and an overflow ring is provided to redist