Air separation device features

During the start-up phase, when the liquid volume accumulates in the condensing evaporator, the gas and liquid mixture will pass through the liquid air and liquid nitrogen throttle valves. When the throttle valve begins to close, due to the large opening of the valve, when the amount of gas and liquid mixture from the lower column to the upper column changes little, and the pressure of the lower column does not increase significantly, it means that the temperature difference of the condensing evaporator has not increased. At this time, the condensing evaporator and the surrounding insulation have been cooled to the low temperature required by the liquid accumulation stage. Due to a large amount of cold production and a large amount of gas liquefaction, the liquid evaporation in the condensing evaporator is also increased. The rising steam produced prevents the flow of liquid from the sieve plate hole, and gradually accumulates liquid on the tray, so the liquid level will drop. In ad

There must be enough smooth straight pipe sections before and after the flow orifice plate. The distance is 10 times of pipe diameter in front of the orifice plate and 5 times of the pipe diameter behind the orifice plate, and no factors affecting the measurement accuracy (such as pipe joint, etc.) are allowed. The inner surface of the pipe weld should also be ground smooth, and the gasket should not extend into the inner diameter of the pipe. And carefully check the installation direction of the orifice plate, do not install it in reverse. (judgment method: the small exit is the entrance, and the large exit is the outlet)